Adjustment Procedure Using Acc Setting Device:Vas 6190: Notes
Special Tools And Workshop Equipment Required
- Vehicle diagnosis, testing and information system:VAS 5051 A
- Diagnostic Cable:VAS 5051/5A
- ACC Adjustment Device:VAS 6190
- Adjustment Tool:VAS 6190/2
- Wheel alignment computer
The :VAS 6190 may have to be adapted for the adjustment procedure. Refer to ACC Setting Device .
Before driving the vehicle onto the alignment stand, check whether there is a sufficiently large space between the vehicle and the :VAS 6190 . The distance between the :VAS 6190 and the vehicle must be 120 cm +/- 5 cm.
If there is not sufficient space, drive vehicle backward on alignment stand in order to be able to use the corresponding space.
- Before beginning the adjustment, check the DTC memory and correct any malfunctions present.
The adjustment procedure is described here with the :VAS 6190 . However the ADC test fixture:VAS 6041 and ADC reflector mirror:VAS 6041/1 can also be used.
If there was a previous axle alignment, the steps under "Calibration procedure without a previous axle alignment" should not performed.