Refrigerant Circuit Connections With Valve For Switches

NOTE:

Switching Pressures, Removing And Installing Switches As Well As Switch Arrangement And Version. Refer to the appropriate information (REFRIGERANT CIRCUIT / REFRIGERANT CIRCUIT / REFRIGERANT CIRCUIT ) (vehicle-specific repair information).

Different threads for switch on high pressure and low pressure sides.
Only valves and seals that are resistant to refrigerant R1234yf and refrigerant oil must be installed. Refer to the Parts Information.

Courtesy of AUDI OF AMERICA, LLC

A - Connection (soldered in)

B - Seal

C - Valve (with Seal)

NOTE:

To remove and install the valve insert -C- when the refrigerant circuit is discharged, use, for example, an adapter from the Refrigerant Sockets:T10364 (Tightening specification. Refer to QUICK-RELEASE COUPLING CONNECTIONS ON REFRIGERANT CIRCUIT ).

There are different versions of these valves and therefore there are different tightening specifications. Valve insert -C- with a VG5 (5.2 x 0.7 mm, tire valve) thread has a tightening specification of 0.4 Nm ± 0.1 Nm ; a valve insert with a M6 x 0.75 mm thread has a tightening specification of 0.9 Nm ± 0.1 Nm , and a valve insert with a M8 x 1.0 mm thread has a tightening specification of 2.0 Nm ± 0.2 Nm .