Flange Shaft Ring, Replacing, 0BD

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

The ring can only be replaced with the final drive and the flange shaft removed.

Special tools and workshop equipment required

Press Plate VW401
Press Plate VW402
Press Piece - Rod VW407
Circlip Sleeve 32 - 119
Bearing Installer - Multiple Use 3062
Separating Tool - 22-115mm, such as Puller - Kukko Quick Action Separating Tool - 22-115mm 17/2

The rear final drive is removed. Refer to FINAL DRIVE, REMOVING AND INSTALLING .
Flange shaft removed. Refer to LEFT SEAL, REPLACING, 0BD .

Fig 1: Pressing Off Dust Cap From Flange Shaft

Courtesy of AUDI OF AMERICA, LLC

A -

Separating Tool - 22-115mm, such as Puller - Kukko Quick Action Separating Tool - 22-115mm 17/2

Fig 2: Installing Ring -A- On Flange Shaft

Courtesy of AUDI OF AMERICA, LLC

Protective ring -A- installation position: the protective ring notch points to the Circlip Sleeve 32 - 119.