Timing Mechanism Drive Chain, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following:

Tightening Specifications. Refer to OVERVIEW - TIMING MECHANISM DRIVE CHAIN .

NOTE:

Replace Any Bolts That Were Tightened With An Additional Turn.

-- Position the timing mechanism drive chain according to the markings made on the drive chain sprockets during removal.

-- Install the guide rail and tighten the bolts -1-.

Fig 1: Identifying Bolts And Chain Tensioner

Courtesy of AUDI OF AMERICA, LLC

-- Install the chain tensioner and tighten the bolts -2-.

-- Press the drive chain tensioner guide rail in direction of -arrow- and pull :T40071 out of the chain tensioner.

-- Install the power take-off drive chain. Refer to POWER TAKE-OFF DRIVE CHAIN, REMOVING AND INSTALLING .

-- Install the camshaft timing chains. Refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .

-- Install the lower timing chain cover. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .