Diagnostic Mode 09 - Read Vehicle Information: Procedure

-- Connect the scan tool.

-- Switch the ignition on.

-- Select Mode 09: Vehicle information.

-- Select the desired Test-ID.

-- The information requested will be displayed on the scan tool screen.

The following table is a numerical list of all Test-IDs that may be selected.

Test-ID	Diagnostic text
02:	Vehicle identification number (VIN) e.g.
	A different 17 digit number will be displayed for each vehicle
04:	Calibration identification (CALID) e.g.
	Calibration Identification (CALID) Part number and software version
06:	Calibration verification number (CVN) check sum e.g.
	EC5AE460 the check sum is different for every control module version
	000D105
0A:	ECM / TCM Name e.g.
	Engine Control Module -J623-
	Transmission Control Module -J217-
08:	In-Use Performance Tracking (IPT - Counter)
	General Denominator: OBDCOND Ignition Cycle Counter: IGNCNTR Function-specific numerators / denominators Catalyst diagnosis O2S probe diagnosis before catalytic converter EGR diagnostic / Camshaft Position - diagnosis Secondary air injection diagnostics EVAP diagnosis O2S probe after catalytic converter diagnosis

-- Switch the ignition off.