Engine Temperature Control Sensor - G694-, Checking

General Description

The Engine Temperature Control Sensor -G694- Sends Information About The Current Coolant Temperature To The Engine Control Module -J623-. It Uses The Coolant Temperature As A Correction Value For Calculating The Injection Quantity.

Special Tools And Workshop Equipment Required

Multimeter.
Wiring Diagram.
Scan Tool.

Test Requirements

Fuses OK.
Battery voltage OK.
Switch OFF all electrical and electronic accessories.
Vehicles with Auto. Transmission, ensure Selector Lever position is in "P".
Vehicles with Man. Transmission, ensure Shifter Lever position is in "N" with Parking Brake applied.
Observe all safety precautions: SAFETY PRECAUTIONS .
View clean working conditions: CLEAN WORKING CONDITIONS .

Test Procedure

Step	Procedure	Result / Action to Take
1	PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK . -- Was Complaint verified?	-- YES: GO TO: Step 2 Engine Temperature Control Sensor - G694-, CHECKING - 2 . -- NO: GATHER more information from customer about the complaint.
2	IGNITION: OFF. DISCONNECT: Engine Temperature Control Sensor -G694- harness connector. CHECK: Engine Temperature Control Sensor -G694- component connector terminals 1 to 2 for resistance. SPECIFIED VALUE: 2, 606 Ω (+/- 314 Ω @ approx. 20° C). -- Was Value obtained?	-- YES: GO TO: Step 3 Engine Temperature Control Sensor - G694-, CHECKING - 3 . -- NO: REPLACE: Engine Temperature Control Sensor -G694-. Refer to the appropriate service information. GO TO: Step 4 Engine Temperature Control Sensor - G694-, CHECKING - 4 .
3	REMOVE: Engine Control Module - J623-. Refer to the appropriate service information. CHECK: Engine Temperature Control Sensor -G694- harness connector terminal 2 to the Engine Control Module - J623- harness connector T94 / 37 for resistance. CHECK: Engine Temperature Control Sensor -G694- harness connector terminal 1 to ground for resistance. A7; Q5 ONLY: CHECK: Engine Temperature Control Sensor -G694- harness connector terminal 2 to the Engine Control Module - J623- harness connector T94 / 38 for resistance. SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω). -- Were Values obtained?	-- YES: GO TO: Step 4 Engine Temperature Control Sensor - G694-, CHECKING - 4 . -- NO: PERFORM: Visual Inspection of wiring and component. CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals. REPAIR: Faulty wiring or connector. GO TO: Step 4 Engine Temperature Control Sensor - G694-, CHECKING - 4 .
4