Headrest Cover And Cushion, Removing And Installing: Removing
WARNING:
- Follow all safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
-- Remove the head restraints:
- Refer to HEADREST, REMOVING AND INSTALLING, HEADREST WITH SLIDING LOCKING MECHANISM .
- Refer to HEADREST, REMOVING AND INSTALLING, POWER HEADREST .
-- Open the side locks -arrows- on the cover -1-.
-- Insert the :3409 in the direction of -arrow A- between the cover zipper -1-.
-- Bend the lower U-channel -3- in the direction of -arrow B-.
-- Pull the upper side of the cover with the flat channel -2- out of the U-channel.
-- Open the main zipper by inserting the :3409 between the zipper and the cover.
-- Bend the lower U-channel -1- in the direction of -arrow A-.
-- Pull the upper side of the cover with the flat channel -2- out of the U-channel.
NOTE:
The cover must be completely open to remove the cushion.
-- Remove the cushion -1- from the cover -2-.