Driver And Front Passenger Backrest Heating Element -Z7- And -Z9-, Removing And Installing, Comfort Seat: Installing

-- Align the new backrest heating element on the cushion.

CAUTION:

Make sure the new backrest bolster heating elements are bonded in the same position as the old ones.
Remove the protective films in the bonding sequence for the heating element area.
When removing the protective films, make sure the heating element is not damaged and that it is attached without wrinkles.

-- Bond the heating element -2- in sequence -A, B, C and D-.

Fig 1: Backrest Heating Element, Comfort Seat

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Route the connecting wires to the individual heating surfaces in the base of the gaps -arrows-.

-- Pull the wire -1- through the slit in the cushion.

Further installation is the reverse order of removal.