Overview - Pressure Sensor
CAUTION:
It is mandatory for run-flat tires to have a tire pressure monitoring system in the vehicle.
The wheel electronics, thus the system pressure sensor creates a physical unit with the valve.
- Tire Pressure Sensor
- Left Front Tire Pressure Monitoring Sensor -G222-
- Right Front Tire Pressure Monitoring Sensor -G223-
- Left Rear Tire Pressure Monitoring Sensor -G224-
- Right Rear Tire Pressure Monitoring Sensor -G225-
- Batteries must be completely replaced.
- Remaining battery life, temperature and pressure can be read via diagnosis using the Vehicle Diagnostic Tester.
- Bolt
4 Nm
NOTE:Only used on Beru systems
- Microencapsulated
- Supplied as a replacement part complete with sensor
- Metal Valve
- Supplied as a replacement part complete with sensor
- Refer to METAL VALVE BODY, REMOVING AND INSTALLING
- Valve Insert
- Rim
- Union Nut
- Always replace if removedNOTE:
Do not counterhold on the metal valve when tightening
- Refer to UNION NUT TIGHTENING SPECIFICATION
- Always replace if removed
- Valve capNOTE:
Always replace if damaged
WARNING:
If tire sealant was used, then the wheel electronics on that particular wheel must be replaced.