Lower Timing Chain Cover - Tightening Specifications And Sequence
WARNING: This page is about a different car, the 2017 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Replace the bolts that were tightened with an additional turn after removing them.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 15- | Install by hand all the way |
| 2. | -1 to 15- | 8 Nm |
| 3. | -1, 2, 4, 5- and -7 to 15- | 45° additional turn |
| 4. | -3 and 6- | After installation of the vibration damper a 45° additional turn |