Perform Adaptations After Component Replacement
The adaptation values must be adapted when components of the engine or reducing agent system are being replaced, or when a reducing agent line was opened:
After replacing the component, the necessary program must be executed using the Vehicle Diagnostic Tester.
-- Connect the Vehicle Diagnostic Tester.
-- Select Diagnostic operating mode and Start diagnostics .
-- Select the Select individual test tab and select the following tree structure consecutively:
- Drivetrain
- Select the engine code and engine
- 01 - OBD-capable systems .
- 01 - Engine Control Module -J623-
- 01 - Engine electronics, functions
- 01 - Steps after replacing component