Bumper Cover, Removing And Installing, A3 With Side Auxiliary Radiator: Removing
-- Left: Push in the front wheel and loosen the wheel housing liner in the area of the front bumper cover.
-- Ring: loosen the lower front wheel housing liner and push to the side, Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .
-- Place a drip tray under the coupling point for the washer fluid hose.
-- Remove the water drain hose -1- from the headlamp washer pump -2- to do this push the release button.
-- Seal the hose coupling with clean plugs from the : VAS6122 .
-- Free up the washer fluid hose -3-.
-- Disconnect the central connector -arrow-.
-- Push the loosened wheel housing liner aside and remove the bolts -arrows-.
-- Remove the bolts -1 and 2-.
-- Disengage the side piece -3- from the front side panel -arrow- and remove the bumper cover forward with a second technician.