Lifter, Removing And Installing: Installing

Install in reverse order of removal and note the following:

-- Clean the adjusting screw threads -3- with a wire brush.

Courtesy of AUDI OF AMERICA, LLC

-- Clean the threaded hole of the lifter -1- of locking compound residue with a thread tap.

-- Check the stop washer -2- for damage.

• The stop washer must sit in the groove -arrow-.

-- Insert the adjusting bolt -3- with locking fluid in the lifter -1-, place in the roof cut out and secure.

-- Install the roof railing. Refer to ROOF RAILING, REMOVING AND INSTALLING .