Wheel Housing Liner Cover, Removing And Installing: Installing
Install in reverse order of removal and note the following:
- The vehicle and the cover must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Clean the adhesive surface on the fender using Cleaning Solution: D 009 401 04 .
-- Remove the protective film from the adhesive tape -1-.
-- Place the cover -2- on the front of the fender by pressing the securing pins -arrows- into the mount.
-- Press the cover on the entire length of the fender -3-.
- Resting time approximately 30 minutes at room temperature