LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> S3 Prestige >> Repair and Diagnosis (Single Page) >> Body & Frame >> Seats >> Seat Frames >> 72 Seat Frames >> Front Seats >> Seat Angle Adjuster, Removing And Installing >> Driver And Front Passenger Seat Angle Adjustment Motor -V243- And -V244-, Removing And Installing >> Removing

Driver And Front Passenger Seat Angle Adjustment Motor -V243- And -V244-, Removing And Installing: Removing

Fig 1: Removing Bolt For Adjusting Spindle
GWWA72-10783Courtesy of AUDI OF AMERICA, LLC

-- Move the front seat into its highest position.

-- Unscrew the front seat and tip to the rear with the wires attached. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Remove the bolt -2- for the seat angle adjustment motor adjustment spindle -1-.

Fig 2: Do Not Damage Bushing Inserted In Bearing Area When Removing Bolt
GWWA72-10792Courtesy of AUDI OF AMERICA, LLC
CAUTION:

Risk of damage to the bushing -1- in the bearing point -2- (adjusting spindle/seat pan bolting).

  • The bushing cannot be replaced with workshop materials.
  • If the bushing is damaged, the corresponding assembly parts must be replaced.

-- Disconnect the connector -3- at the seat angle adjustment motor.

Fig 3: Disconnect Electrical Harness Connector On Seat Angle Adjustment Motor
GWWA72-10780Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- and the seat angle adjustment motor -4-.

scientia non olet · About LEMON Manuals