DRIVER AND FRONT PASSENGER BACKREST ADJUSTMENT MOTOR Driver Backrest Adjustment Motor -V45- /Front Passenger Backrest Adjustment Motor -V46-, REMOVING AND INSTALLING: Installing
- Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
- Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
- Follow all the instructions when installing the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Check the position of the backrest frame -2- and the hinge -1- on the left and right side.
- The left and right side of the backrest frame must be in the position marked before removal -A and B arrows-.
-- If the left and right side of the backrest frame are not in the position marked before removal, correct the position accordingly.
-- Set backrest adjustment motor -3- with bracket in place.
- It must still be possible to move the backrest adjustment motor.
-- First slide the adjustment shaft through the hinge (tunnel side) as far as the mount -4- in the backrest adjustment motor.
-- Check if the profiles of the inserted adjustment shaft and the mount in the backrest adjustment motor are congruent to each other.
-- For adjustment, connect an external 12-volt power source to the backrest adjustment motor -3- and turn mount until the profiles of adjustment shaft and mount are aligned.
-- Slide the adjustment shaft -5- through the mount in the backrest adjustment motor as far as the stop (sill panel trim) -arrow-.
-- Install the new nut -3- on the adjustment shaft -4- and tighten it.
-- Rivet bracket with motor to the backrest frame -2- -1-.
Further installation is performed in reverse order of the removal.