Overview - Bumper Cover, A3 And SPORTBACK From My 2017

Fig 1: Bumper Cover Components Location (A3 And Sportback From MY 2017)

Courtesy of AUDI OF AMERICA, LLC

1. Rear Reflector
   • Removing and Installing. Refer to REFLECTOR, REMOVING AND INSTALLING .
2. Rear Bumper Cover
   • Removing and Installing. Refer to BUMPER COVER, REMOVING AND INSTALLING .
3. Cover
4. Bolt
   • 2 Nm
5. Mount
   • For the bumper cover
   • Removing and Installing. Refer to BUMPER COVER MOUNT, REMOVING AND INSTALLING .
6. Side Mount
   • For the bumper cover
   • Removing and Installing. Refer to SIDE BUMPER COVER MOUNT, REMOVING AND INSTALLING, A3 AND SPORTBACK .
7. Bolt
   • Quantity: 4
   • Tightening sequence. Refer to Figure.
8. Nut
   • Tightening sequence. Refer to Figure.
9. Locking Mechanism
   • For attaching the rear bumper cover to the upper mount
10. Cover
    • Quantity: 4
11. Nut
    • 5 Nm
    • Quantity: 4
12. Nut
    • 2 Nm
    • Quantity: 2
13. Cover
    • For the towing eye
14. Trim
    • Only S line version
    • For the bumper cover
    • Removing and Installing. Refer to BUMPER COVER TRIM, REMOVING AND INSTALLING, A3 S LINE AND SPORTBACK S LINE FROM MY 2017 .
15. Bumper Cover Lower Section
    • Removing and Installing. Refer to BUMPER COVER LOWER SECTION, REMOVING AND INSTALLING .
16. Trim
    • Only S line version
    • For the bumper cover lower section
    • Removing and Installing. Refer to BUMPER COVER LOWER SECTION TRIM, REMOVING AND INSTALLING, S LINE FROM MY 2017 .