Front Parking Aid Sensors -G252-/- G253-/-G254-/-G255-, Removing And Installing, AUDI S Line/S3 Through My 2016: Removing
Outer Sensors
- Vehicle equipment version with left auxiliary cooler: Remove the auxiliary cooler and set it aside with the coolant hoses attached. Refer to → Radiator/Coolant Fan; Auxiliary Cooler, Removing and Installing.
- Right: Remove the front wheel housing liner. Refer to → Front Wheel Housing Liner, Removing and Installing.
- Press both tabs in direction of -arrows- to the side and press the sensor -3- inward from the outside.
- Disconnect the connector -2- by sliding the retainer -1- back and pressing the release down.
Inner Sensor
- Remove the front bumper cover end plate. Refer to → Front Bumper; Bumper Cover Assembly Overview.
- Audi RS3: Remove the front bumper cover. Refer to → Front Bumper; Bumper Cover Removing and Installing.
- Press both tabs in direction of -arrows- to the side and press the sensor -3- inward from the outside.
- Disconnect the connector -2- by sliding the retainer -1- back and pressing the release down.