Rear Axle Camber

Camber cannot be adjusted.

If measured values are not within the specified range, check the axle beam for damage and replace if necessary.

Special tools and workshop equipment required 

• Torque Wrench 1332 40-200Nm :VAG1332 
• 18 mm socket from the Shock Absorber Set :T10001 
• Insert Tool - 18mm :T10179 

-- Remove the nut -A- on the upper control arm threaded connection from the subframe and loosely install a new nut.

Courtesy of AUDI OF AMERICA, LLC

-- Set the camber by turning the eccentric bolt -B-.

• Use the 18 mm socket -1- from the :T10001  To turn the eccentric bolt, turn the hex head at the "top of the bolt".

  Courtesy of AUDI OF AMERICA, LLC

-- Tighten the nut -A- using the :T10179  .

Courtesy of AUDI OF AMERICA, LLC

-- Use the :T10179  -1- as shown.

Courtesy of AUDI OF AMERICA, LLC

-- After the nut is tightened, check the camber value once more. Refer to AXLE ALIGNMENT SPECIFIED VALUES .

Tightening Specifications 

• Refer to OVERVIEW - TRANSVERSE LINK .