Rear Parking Aid Sensor, Removing And Installing: Removing
Outer Sensors
- Press both tabs in direction of -arrows- to the side and press the sensor -3- inward from the outside.
- Disconnect the connector -2- by sliding the retainer -1- back and pressing the release down.
Inner Sensor
- For vehicles without a trailer hitch, remove the bolts -arrows-.
- For vehicles with a trailer hitch, remove the rear bumper cover. Refer to → Rear Bumper; Bumper Cover, Removing and Installing.
- Press both tabs in direction of -arrows- to the side and press the sensor -3- inward from the outside.
- Disconnect the connector -2- by sliding the retainer -1- back and pressing the release down.
NOTE:
If the sensor cannot be removed as described on vehicles without a trailer hitch, the rear bumper cover must be removed. Refer to → Rear Bumper; Bumper Cover, Removing and Installing.