Schematic Overview - Coolant Flushing And Filling Device:Vas531007:
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Reservoir with Distilled Water
- Fill with at least 20 liters of distilled water
- Reservoir with Coolant
- Fill with at least 20 liters of coolant
- Coolant additive up to approximately -36 °C (33 °F)
- Empty Container
- For used coolant
- Empty Container
- For used coolant
- Suction Hose
- Comes from the connection 2 on the viewing glass
- Viewing Glass
- If colored the viewing glass must be cleaned with a nylon brush
- Pump
- Cut-off pressure approximately 1.5 bar (22 PSI)
- Valve Block
- With pressure gauge and shut-off valves
- Drain Hose
- Is connected to the valve block to reduce the pressure
- Flushing Hoses
- Is connected for flushing on the coolant expansion tank bleeder hose
- Comes from the connection 1 on the viewing glass
- If not used seal with plugs
- Plugs
- Hose Clamps
- Quantity: 4
- Cleaning Adapters
- Approximately 15 cm long
- For cleaning the :VAS531007 after the flushing procedure
- Is connected between the valve block and the flushing hose item ) COOLING SYSTEM, FLUSHING - Flushing Hoses
- Extraction Adapter
- Approximately 100 cm long
- Is connected to the suction hose item ) COOLING SYSTEM, FLUSHING - Suction Hose in order to extract the coolant