Engine Coolant Temperature Sensor -G62-, Removing And Installing: Installing
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install In Reverse Order Of Removal. Note The Following:
- Replace the O-rings.
- Replace the spacer ring if damaged.
-- Retighten the left coolant pipes.
CAUTION:
- The coolant system must be bled using the Vehicle Diagnostic Tester after filling.
-- Bleed the cooling system. Refer to COOLANT, DRAINING AND FILLING WITHOUT COOLING SYSTEM CHARGE KIT - ELECTRIC VACUUM PUMP:VAS6096/2 .