Engine, Securing To Engine And Transmission Holder
WARNING: This page is about a different car, the 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Engine Sling:2024A
- Holding Fixture:VW540
- Engine and Transmission Holder:VAS6095A
- Shop Crane:VAS6100
Procedure
- Transmission separated from engine. Refer to ENGINE, REMOVING AND INSTALLING .
-- If equipped, release the retainer in direction of -arrow- and remove the engine cover mount -1-.
-- Engage the :2024A onto the engine and onto the :VAS6100 .
- To be aligned to the center of gravity of the assemblies, the mounting hook rail with holes must be inserted as shown.
CAUTION:
There Is a Risk of Injury from the Lifted Engine Falling.
Parts of the Body Could Be Crushed.
- Secure the mounting hooks and pins on the lifting tackle with a securing pin.
-- Insert the securing pins -arrows- to secure the mounting hooks and alignment pins.
-- Tighten the :VW540 on the transmission side as shown on the engine with the bolts -arrows- and nut -2-.
-- Secure the :VW540 with mounting pin -3- and cotter pin -1- on the :VAS6095A .