LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> S3 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (ENGINE ASSEMBLY [4-Cylinder Direct Injection 1.8L; 2.0L 4V TFSI Engine] -- (A3)) >> 10 Engine Assembly >> SUBFRAME Mount >> Transmission Mount, Removing And Installing >> Installing

Transmission Mount, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

NOTE:

Replace the bolts that were tightened with an additional turn.

-- Secure the transmission support to the longitudinal member.

CAUTION:

Risk of damaging threads in transmission support by inserting bolts at an angle.

  • The transmission support and the transmission support arm must be absolutely parallel to each other before installing the bolts. Push the rear of the transmission upward using a floor jack if necessary.
  • Remove the :10-222A  only when the bolts for the subframe mount have been tightened to the tightening specification.

-- Lift the transmission using the engine support bridge spindle until the transmission support touches the support arm.

-- Check the adjustment of the subframe mount. Refer to SUBFRAME MOUNT, CHECKING ADJUSTMENT .

-- Remove the :10-222A  from the engine. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .

-- Install the Engine Control Module -J623-. Refer to Engine Control Module -J623-, REMOVING AND INSTALLING .

-- Install the battery tray. Refer to BATTERY .

scientia non olet · About LEMON Manuals