Engine And Transmission, Separating, Vehicles With Manual Transmission 02S: Procedure
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Engine/transmission assembly removed and mounted on :T10359A .
-- Remove the starter. Refer to STARTER .
-- Free up the wiring harness -1 and 2- from the air duct pipe.
-- Loosen the screw-type clamp -4-.
-- Remove the bolts -arrows- and remove the air duct pipe.
-- Remove the bolts -arrows- and transmission support -A- from the transmission.
-- Secure the transmission to the :VAS6100 using the :2024A as shown.
NOTE:
To be aligned to the center of gravity of the assembly, the rails with holes of the lifting hooks must be inserted as shown.
WARNING:
Risk of accident due to loose engine support bridge components.
- Secure the mounting hooks and pins on the engine support bridge using securing pins -arrows-.
-- Remove the bolts -1, 2, 3, 6, 7, 8 and 9- connecting the transmission to the engine.
-- Remove the transmission from the engine.