Coolant Pump, Removing And Installing: Installing
WARNING: This page is about a different car, the 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Install the coolant pump -1- and toothed belt.
-- Pay attention that the centering piece -arrows- and seal -3- are seated correctly.
-- Tighten the coolant pump bolts. Refer to Figure.
-- After installing a new coolant pump -2-, remove the protective cap -1- from the drive wheel.
There are additional procedures depending on the model. Refer to COOLANT PUMP/COOLANT THERMOSTAT .