Timing Chain Cover, Removing And Installing, Engine With Two Camshaft Adjusters: Installing

WARNING: This page is about a different car, the 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal and Note The Following:

Replace the seals and O-rings after removal.

-- Coat the seals and the O-rings with engine oil.

Seal installation position: smaller inner diameter outward.

-- Install the camshaft adjustment valves. Refer to CAMSHAFT ADJUSTMENT VALVE 1 -N205-, REMOVING AND INSTALLING .

Additional procedures depending on the model. Refer to TIMING CHAIN COVER [CNSB, CNTC, CYFB] .