Lower Timing Chain Cover, Replacing: Removing

• Engine Oil Drained. Refer to the appropriate service information ENGINE OIL .

Depending on the model preliminary work may be required. Refer to TIMING CHAIN COVER [CNSB, CNTC, CYFB] .

-- Remove the engine support. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING [CNSB, CNTC, CYFB] (4-Cylinder 2.0L 4V TFSI) / ENGINE SUPPORT, REMOVING AND INSTALLING [CNSB, CNTC, and CYFB] (4-Cylinder Direct Injection 1.8L; 2.0L) .

-- Remove the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .

-- Remove the ribbed belt tensioner. Refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING .

-- Free up the clip -2- for the wiring harness.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1-.

-- Unclip the oil dipstick tube on the upper timing chain cover in direction of -arrow- and remove from the lower timing chain cover.

-- Disconnect the connector -1- for the Oil Pressure Regulation Valve -N428-.

Courtesy of AUDI OF AMERICA, LLC

-- If equipped, remove the bolt -2- and remove the bracket -1- for the air duct pipe.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 through 15-.

Fig 1: Lower Timing Chain Cover Bolts - Tightening Sequence (15 Bolts)

Courtesy of AUDI OF AMERICA, LLC

TIP: 

There may be only eight bolts installed, depending on the version.

-- Remove the lower timing chain cover from the bonding.