Camshaft Adjustment Valve 1 - N205-, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Replace the O-ring.

-- An adaptation must be performed after replacing or removing and installing the Camshaft Adjustment Valve 1 -N205- by using the Vehicle Diagnostic Tester under Guided Functions , 01 - Adapting the Electric Actuator with Feedback .

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .