LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> S3 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (CYLINDER HEAD, VALVETRAIN (4-Cylinder TDI Common Rail 1.6L; 2.0L 4V Engine) -- (A3 SEDAN)) >> 15 Cylinder Head, VALVETRAIN >> VALVETRAIN >> Camshaft Adjuster, Removing And Installing >> Installing

Camshaft Adjuster, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following: 

CAUTION:

- Check the installation of the friction disc (diamond disc) between the camshaft adjuster and the camshaft stub.

-- Pay attention after installing the friction disc

-- Install the upper toothed belt guard. Refer to UPPER TOOTHED BELT GUARD, REMOVING AND INSTALLING .

-- An adaptation must be performed after replacing or removing and installing the camshaft adjuster by using the Vehicle Diagnostic Tester under Guided Functions  , 01 - Adapting the Electric Actuator with Feedback  .

scientia non olet · About LEMON Manuals