Overview - Charge Air System: Notes

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Charge Air System

Courtesy of AUDI OF AMERICA, LLC

Seal
- Always replace after removing
Alignment Pin
Bolt
- 8 Nm
Seal
- Always replace after removing
Bolt
- Tightening specification -item 5- OVERVIEW - INTAKE MANIFOLD .
Bracket
- For intake manifold
Bolt
- Tightening specification -item 7- OVERVIEW - INTAKE MANIFOLD .
Bolt
- Tightening specification and sequence. Refer to CHARGE AIR PRESSURE SENSOR G31 - TIGHTENING SPECIFICATION
- Always replace
Alignment Pin
Bolt
- 8 Nm
Intake Manifold with Charge Air Cooler
- The intake manifold with charge air cooler are one unit.
- Removing and installing. Refer to INTAKE MANIFOLD, REMOVING AND INSTALLING .
Bolt
- Tightening specification and sequence. Refer to CHARGE AIR PRESSURE SENSOR G31 - TIGHTENING SPECIFICATION
- Always replace
Charge Air Temperature Sensor After Charge Air Cooler -G811-
- 22 Nm
- Removing and installing. Refer to CHARGE AIR TEMPERATURE SENSOR, REMOVING AND INSTALLING .
Seal
- Always replace after removing
Connection
- For Throttle Valve Control Module -J338-
Charge Air Temperature Sensor In Front Of Charge Air Cooler -G810-
- 22 Nm
- Removing and installing. Refer to CHARGE AIR TEMPERATURE SENSOR, REMOVING AND INSTALLING .
Bolt
- 10 Nm
- Not delivered separately
Coolant Pipe
- Not delivered separately
Bolt
- 10 Nm
- Not delivered separately
Coolant Pipe
- Not delivered separately
O-rings
- Not delivered separately
- Coat with coolant
Throttle Valve Control Module -J338-
- With Throttle Position Sensor -G69-
- Removing and installing. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .
O-ring
- Always replace after removing
Air Guide Pipe
Bolt
- 8 Nm
Bracket
- For Throttle Valve Control Module -J338-
Bolt
- Tightening specification and sequence. Refer to CHARGE AIR PRESSURE SENSOR G31 - TIGHTENING SPECIFICATION
Bolt
- Tightening specification and sequence. Refer to CHARGE AIR PRESSURE SENSOR G31 - TIGHTENING SPECIFICATION