Intake Manifold Bracket And Throttle Valve Control Module Bracket - Tightening Specification And Sequence

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Intake Manifold And Throttle Valve Control Bracket Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Tighten The Bolts In Steps:

TIP

When installing the bracket for the intake manifold or the throttle valve control module, make sure that the respective bracket is not installed under tension.

Step	Bolts/Nuts	Tightening Specification
1.	-2, 3, 4, 7-	Install all the way by hand
2.	-2, 3, 4, 7-	Tighten to 20 Nm.
3.	-5-	Tighten to 10 Nm.
4.	-1-	Tighten to 10 Nm.