Wiring Diagram CALLOUTS (Engine Control Module, Fuel Metering Valve, After-Run Coolant Pump)

J623 

Engine control module Type:BT, Slpdok:, Aim:BTJ623

J883 

Exhaust door control unit

N290 

Fuel metering valve Type:BT, Slpdok:, Aim:BTN290

T2ja 

2-pin connector, black

T3as 

3-pin connector, black

T3az 

3-pin connector, black

T14 

14-pin connector, gray Type:BT, Slpdok:, Aim:BTT14

T17c 

17-pin connector, on the lower left A-pillar, red Type:BT, Slpdok:, Aim:BTT17c

T91 

91-pin connector, black

T105 

105-pin connector, black

V51 

After-run coolant pump Type:BT, Slpdok:, Aim:BTV51

201   - Ground connection 5 (in engine compartment wiring harness)

373   - Ground connection 8 (in main wiring harness)

484   - Ignition coil ground connection 2 (in engine pre-wiring harness)

B350   - Positive connection 1 (87a) (in main wiring harness)

*  Depending On Equipment

*2  Only For Cabriolet

*3  Only For Vehicles With 4-Door Equipment

*4  Only For Vehicles With 5-Door Equipment

*5  Only For Vehicles With A Parking Heater

*6  Only For Vehicles With 3-Door Equipment