Overview - Emissions Control System: Notes
- Bolt
- 20 Nm
- Bracket
- Replace if damaged
- Bolt
Tightening specification and sequence. Refer to CATALYTIC CONVERTER - TIGHTENING SPECIFICATION AND SEQUENCE .
- Nut
Tightening specification and sequence. Refer to CATALYTIC CONVERTER - TIGHTENING SPECIFICATION AND SEQUENCE .
- Bracket
- For catalytic converter
- Catalytic Converter
- With front exhaust pipe
- Protect catalytic converter from shocks and impact stress
- Removing and installing. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING .
- Exhaust System, Installing without Tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
- Screw-Type Clamp
- 15 Nm
- Always replace
- Tightening specification and sequence. Refer to CATALYTIC CONVERTER - TIGHTENING SPECIFICATION AND SEQUENCE .
- Installation position. Refer to INSTALLATION POSITION OF THE CATALYTIC CONVERTER SCREW-TYPE CLAMP .
- Seal
- Always replace
- Turbocharger
- Removing and installing. Refer to TURBOCHARGER .
- Nut
Tightening specification and sequence. Refer to CATALYTIC CONVERTER - TIGHTENING SPECIFICATION AND SEQUENCE .
- Nut
- 23 Nm
- Front Clamping Sleeve
- Before tightening, align the exhaust system without tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
- Tighten threaded connections evenly.
- Installation position. Refer to INSTALLATION POSITION FOR FRONT CLAMPING SLEEVE .