Fuel Level Sensor 2 -G169-, Removing And Installing: Installing

-- Insert the Fuel Level Sensor 2 -G169- in the guides on the bracket and push down until it engages.

-- Install a new sealing flange seal -1-. It must be dry.

Fig 1: Identifying Sealing Flange Installation Position

Courtesy of AUDI OF AMERICA, LLC

-- Bring the sealing flange into its installation position.

• The tab -2- on the sealing flange must face the hole -arrow- in the locking ring and rest between the tabs -3 and 4- on the fuel tank.

-- Insert the locking ring and fasten using the :T10202  .

Fig 2: Identifying Fuel Sending Unit Wrench

Courtesy of AUDI OF AMERICA, LLC

Further installation is performed in reverse order of removal, while noting the following:

-- Install the rear bench seat. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .