Overview - Fuel Tank, With Front Wheel Drive (Fwd)

Fig 1: Fuel Tank, With Front Wheel Drive (FWD) (Overview)

Courtesy of AUDI OF AMERICA, LLC

1. Bolts
   • 20 Nm + 90° 
   • Always replace after removing
2. Fuel Supply Line
   • To the engine
   • Clipped to the fuel tank
   • Do not kink
   • Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
3. Breather Line
   • To EVAP Canister Purge Regulator Valve 1 -N80-
   • Clipped to the fuel tank
   • Do not kink
   • Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
4. Bolt
   • 8 Nm + 90° 
   • Always replace after removing
   • To attach the fuel filler neck
   • For discharging electrostatic charge. Refer to Figure.
5. Ground Connection
   • For fuel filler tube
   • For discharging electrostatic charge. Refer to Figure.
6. Cap
   • Turn until it clicks into place.
   • Attached to the fuel filler door unit with fastening device
7. Breather Line
   • To the EVAP canister
   • Clipped to the fuel tank
   • Do not kink
   • Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
8. Breather Line
   • To the Evaporative Emission (EVAP) canister
   • Clipped to the fuel tank
   • Do not kink
   • Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
9. Bolt
   • 8 Nm + 90° 
   • Always replace after removing
10. Bolt
    • 20 Nm + 90° 
    • Always replace after removing
11. Fuel Tank
    • Removing and installing. Refer to FUEL TANK, REMOVING AND INSTALLING, FWD VEHICLES AND MULTI-LINK SUSPENSION .
12. Heat Shield
    • For the fuel tank
13. Bolt
    • 20 Nm + 90° 
    • Always replace after removing
14. Nut
    • 2 Nm 
    • For heat shield
15. Mounting Strap