AWD Control Module -J492-
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Installed location of the All Wheel Drive Control Module -J492-. Refer to TRANSMISSION CONTROL COMPONENT LOCATION OVERVIEW .
Removing and installing is on the A4 Sedan.
- The ignition is off.
-- Remove the luggage compartment floor covering.
-- Remove the covering and the vehicle tools bracket.
-- Remove the All Wheel Drive Control Module -J492- -A- from the bracket -C-.
Fig 1: All Wheel Drive (AWD) Control Module -J492- In Audi A4 Sedan, Audi A5 Coupe And Audi A5 Cabriolet
-- Disconnect the connector -B- from the All Wheel Drive Control Module -J492-.
-- Install the All Wheel Drive Control Module -J492- in reverse order of removal.
- If the All Wheel Drive Control Module -J492- was replaced then additional work is necessary. Refer to ADDITIONAL WORK AFTER REPLACING All Wheel Drive Control Module -J492- .