Fuel Pump Control Module -J538-, REMOVING AND INSTALLING: Removing
-- Follow all safety precautions. Refer to SAFETY PRECAUTIONS .
-- Follow the guidelines for clean working conditions. Refer to CLEAN WORKING CONDITIONS .
Risk of damaging electronic components when disconnecting the battery.
- Complete the steps for disconnecting the battery.
-- Disconnect the ground cable from the battery terminal. Refer to BATTERY . .
Risk of accident due to the weight of the fuel tank.
- The fuel tank must be empty when it is lowered.
-- Drain the fuel tank. Refer to FUEL TANK, DRAINING .
-- Remove the right rear wheel housing liner. Refer to WHEEL HOUSING LINER . .
-- Remove fuel filler tube bolts -1 and 2-.
Risk of accident due to the weight of the fuel tank.
- The fuel tank must be empty when it is lowered.
-- Remove the bolts -1 through 6-.
The fuel tank lowers onto the subframe.
The fuel tank is shown without the subframe to provide a more clear illustration.
-- Remove the rear bench seat. Refer to REAR SEATS . .
-- Fold the insulation mat near the locking flange cover to the side.
-- Remove the bolts -arrows- and the locking flange cover.
-- Remove the bolts -1 and 2-.
-- Remove the Fuel Pump Control Module -J538- toward the inside between the fuel tank and the underbody -arrow-.
-- Disconnect the connector -arrow- and remove the Fuel Pump Control Module -J538-.