LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> RS 7 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Rear Final Drive 0BC, 0BD, 0BE & 0BF) >> 39 Final Drive, Differential >> Removal And Installation >> Hydraulic Control Module, 0BE, 0BF >> Removing >> Notes

Hydraulic Control Module, 0BE, 0BF: Removing: Notes

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Place the vehicle on a lift.

-- Lower the back section of the exhaust system just a little and secure it. If necessary remove the back section of the exhaust system. Refer to [For engine(s) CEUC,CRDB] Exhaust System, Emission Controls[For engine(s) CTUA,CGXB] Exhaust System, Emission Controls[For engine(s) CPNB] Exhaust System, Emission Controls .

NOTE:

A second technician is needed to help remove the rear section of the exhaust system.