Driveshaft, Removing From Rear Final Drive And Installing: Notes

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Counterhold Tool T10172A
Adapter T10172/5 (M8 Bolts)
Adapter T10172/6 (M10 Bolts)
High Temperature Grease G 000 633

Note the instructions, refer to DRIVESHAFT, BOLTS ON TRANSMISSION SIDE OVERVIEW .
A twin-pillar lifting platform should be used when working on the driveshaft.

Drive Shaft, Removing from Rear Final Drive

Fig 1: Clamping Sleeves

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the exhaust system at the clamping sleeves -1- and -2-.

-- Tie the exhaust pipe(s) to the underbody.

NOTE:

Do not bend the flex joint in the front exhaust pipe more than 10° or it will be damaged. Secure the front exhaust pipes up on the body and to the side.

A second technician is needed to help remove the rear section of the exhaust system.

-- Remove the rear section of the exhaust system. Refer to [For engine(s) CEUC,CRDB] Exhaust System, Emission Controls [For engine(s) CTUA,CGXB] Exhaust System, Emission Controls [For engine(s) CPNB] Exhaust System, Emission Controls .

-- Check whether there is a color marking on the driveshaft and at flange/driveshaft on the rear final drive -arrow A- and -arrow B-.

Fig 2: Identifying Mark Position Of Driveshaft Flange To Rear Final Drive

Courtesy of AUDI OF AMERICA, LLC

-- If one of these markings is no longer visible (for example -arrow A- on the driveshaft), then make a mark for the missing markings in color.

The dot on the driveshaft -arrow A- and on the rear final drive -arrow B- are on one line.

-- Remove the bolts -1- (quantity: 6) from the rear CV joint.

Fig 3: Counter Hold Using Counterhold Tool Touareg V10 T10172 And Adapters T10172/5

Courtesy of AUDI OF AMERICA, LLC

-- When doing this, counterhold using the Counterhold Tool T10172A and Adapter T10172/5 or Adapter T10172/6.

-- Remove the driveshaft from the rear final drive and move it to the side of the subframe.