Final Drive 0BC, 0BD Overview: Notes
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Rear Final Drive
- Subframe
- Removing and installing, refer toSUBFRAME .
- Bolt
- 95 Nm
- Bolt
- 55 Nm
- Bolt
- 55 Nm
- Depending on the date of manufacture for the balance weight mounting Balance Weight on the Rear Final Drive
- Heat Shield
- Bolt
- 20 Nm
- Drive Axle
- Removing and installing, refer to DRIVE AXLE
- Rear Final Drive
- Versions with balance weight Balance Weight on the Rear Final Drive
- Removing and installing, refer to FINAL DRIVE
- Driveshaft
- Removing and installing, refer to DRIVESHAFT, DRIVESHAFT CONNECTED ON TRANSMISSION SIDE or DRIVESHAFT, DRIVESHAFT BOLTED ON TRANSMISSION SIDE .
- Removing and installing on the rear final drive, refer to DRIVESHAFT, REMOVING FROM REAR FINAL DRIVE AND INSTALLING
- Crossmember