Flywheel, Removing And Installing: Removing
WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
- Secure the transmission on the Engine And Transmission Holder :VAS6095 . Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .
-- Remove the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .
-- Attach the Puller - Clutch Module :T40176 to the flywheel -A- with the nut -B- -arrow-.
-- Turn the Puller - Clutch Module :T40176 upward.
NOTE:
To prevent the flywheel from tilting, counterhold it underneath as illustrated.
-- Remove the flywheel from the input shaft -arrow-. Do not tilt the flywheel when doing this.