Overview - Fuel Tank [XXXX]: Notes

Fig 1: Exploded View Of Fuel Tank [XXXX}

Courtesy of AUDI OF AMERICA, LLC

1. Bolt
   • 20 Nm
2. Suspended Mount
   • For exhaust system
   • Individual components of the mount. Refer to Fuel Tank Suspended Mount, Mounting Strap and Ground Connection. 
3. Mounting Strap
   • Individual components of the mount. Refer to Fuel Tank Suspended Mount, Mounting Strap and Ground Connection. 
4. Adjusting Buffer
   • Individual components of the mount. Refer to Fuel Tank Suspended Mount, Mounting Strap and Ground Connection. 
5. Spacer Sleeve
   • Individual components of the mount. Refer to Fuel Tank Suspended Mount, Mounting Strap and Ground Connection. 
6. Fuel Line
   • From the fuel pressure regulator to the engine
   • Do not kink
   • Clipped to the fuel tank
   • Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, SEPARATING .
7. Bolt
   • 20 Nm
8. Overflow Hose
9. Fuel Filler Door Insert
10. Cap
    • Turn until it clicks and locks.
    • Attached to the fuel filler door insert with an permanent fastener
11. Bolt
    • 20 Nm
    • To attach the fuel filler neck
12. Ground Connection
    • For fuel filler tube
    • For discharging electrostatic charge. Refer to Fuel Tank Suspended Mount, Mounting Strap and Ground Connection .
13. Fuel Tank
    • Removing and installing. Refer to FUEL TANK, REMOVING AND INSTALLING .
14. Breather Line
    • To the EVAP canister
    • Do not kink
    • Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, SEPARATING .
15. Heat Shield
    • For the fuel tank
16. Lock Washer
    • 2 Nm
    • For heat shield
17. Carrier Plate
18. Bolt
    • 20 Nm
19. Heat Shield
    • For the fuel tank
20. Lock Washer
    • 2 Nm
    • For heat shield
21. Expanding Clip

-- Route the ground connection as illustrated.

-- Make sure the following connectors are secure:

• Connector -2- for the ground connection on the threaded ring -1- of the fuel filler tube.
• Ground connector -6- on the fuel filler tube cover.

-- Attach the ground connection contact -4- to the hole in the fuel tank -3- and then install the spacer -5-.