Fuel Pump Control Module -J538-, REMOVING AND INSTALLING: Installing

Fig 1: Tightening Sequence Of Fuel Tank

Install in reverse order of removal. Note the following:

-- Tighten the bolts -1 through 6- on the mounting strap and the support plate.

-- Tighten the fuel filler tube bolts -1 and 2-.

-- Install the right locking flange cover. Refer to Tighten The Cover Screws 1.5Nm .

-- Install the rear bench seat. Refer to REAR SEATS . .

-- Connect the batter while doing so follow all steps after connecting the battery. Refer to BATTERY . .