Overview - EVAP Canister System
- Fuel Tank Leak Detection Control Module -J909-
- With integrated Fuel Tank Pressure Sensor -G400-
- Installed location: On the left side at the back of the underbody under the cover
- Removing and installing. Refer to LEAK DETECTION PUMP, REMOVING AND INSTALLING .
- Bolt
- 1.5 Nm
- Quantity: 3
- Bolt
- 20 Nm
- Quantity: 3
- Rubber Grommet
- Quantity: 3
- Bushing
- Quantity: 3
- Bracket
- Nut
- 8 Nm
- Air Filter
- For the leak detection system
- Installed location: under the wheel housing liner in left rear wheel housing
- Removing and installing. Refer to LEAK DETECTION SYSTEM AIR FILTER, REMOVING AND INSTALLING .
- Vent Line
- To the leak detection system air filter
- Vent Line
- From the fuel tank
- Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, SEPARATING .
- EVAP Canister
- Installed location: on the left side at the back of the underbody under the cover
- Removing and installing. Refer to EVAP CANISTER, REMOVING AND INSTALLING .
- Breather Line
- To EVAP Canister Purge Regulator Valve 1 -N80-
- Connector coupling, separating and connecting. Refer to CONNECTOR COUPLINGS, SEPARATING .
- Clipped in the bracket
- Bracket
- Bolt
- 20 Nm
- Clamp
- Must be appropriate for the model type.
- Seal