Airbag Unit With Igniter, Removing And Installing, Vehicles Through My 2016: Removing
- Follow all safety precautions when working on pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
- Follow all regulations when disposing of pyrotechnic components. Refer to AIRBAG, BELT TENSIONER AND BATTERY CUT-OUT UNITS, STORING, TRANSPORTING AND DISPOSING (PYROTECHNIC COMPONENTS) .
-- Move the steering wheel as far to the rear and down as possible. Use the full steering column adjustment range for this.
-- Disconnect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Turn the steering wheel so the opening on the rear side of the steering wheel faces directly upward. This is approximately the 12 o'clock position.
-- Releases the locking bracket -1- for the driver side airbag -2- -arrows-. Use a T25 TORX® screwdriver, approximately 100 mm long.
Wires can be damaged with a flat-head screwdriver.
-- Turn the steering wheel back 180° and repeat the procedure on the opposite steering wheel side.
-- Bring the steering wheel back into the center (wheels are straight).
Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
-- Remove the driver side airbag -3- from the steering wheel slightly.
-- Pull out the connector lock -2- -arrow- and press it down, disconnect the connector -1-.
-- Vehicles with a multifunction and Tiptronic steering wheel: Disconnect the connector.
Set the airbag down so the impact cushion faces upward.