LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> RS 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (GENERIC SCAN TOOL [CNTA, CNTC, CNSB] (4 Of 5) -- (A3 SEDAN)) >> St Generic Scan Tool >> Diagnosis And Testing >> Readiness Code >> Readiness Codes And Monitoring Completed

Readiness Codes And Monitoring Completed

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A3 Quattro, 2017 Audi A3 Quattro, 2016 Audi A3 Quattro, 2016 Audi A3, and 2015 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
  1. If any engine monitor fails the drive cycle test, repeat the drive cycle test until all engine monitors have successfully run through and passed.
  2. If the drive cycle operation fails again:
  3. Check the DTC memory for stored DTCs.
  4. Repair the vehicle if necessary.
  5. Repeat the drive cycle operation until all engine monitors have successfully run through and passed.
  6. Remove the scan tool and switch the ignition off.
scientia non olet · About LEMON Manuals