LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> RS 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (GENERIC SCAN TOOL [CNTA, CNTC, CNSB] (4 Of 5) -- (A3 SEDAN)) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 07 - Read Faults Detected During The Current Or Last Driving Cycle >> Notes

Diagnostic Mode 07 - Read Faults Detected During The Current Or Last Driving Cycle: Notes

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A3 Quattro, 2017 Audi A3 Quattro, 2016 Audi A3 Quattro, 2016 Audi A3, and 2015 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Mode 07 makes it possible to check emission related faults which appeared during the current or last driving cycle (pending DTCs).

A pending DTC is saved the first time a fault is detected (output via Mode 07).

-- If the fault is detected again by the end of the following driving cycle, a confirmed DTC is entered (output via Mode 03) and the MIL is activated.

-- If this malfunction is not detected again by the end of the following driving cycle, the corresponding pending code will be deleted at the end of the driving cycle.

NOTE:

Depending on the scan tool and protocol used, some of the information provided may be referred to by a different name.

scientia non olet · About LEMON Manuals