LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> RS 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (GENERIC SCAN TOOL [CNTA, CNTC, CNSB] (4 Of 5) -- (A3 SEDAN)) >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Modes 01 - 0A >> Diagnostic Mode 01 - Read Current System Data >> Notes

Diagnostic Mode 01 - Read Current System Data: Notes

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A3 Quattro, 2017 Audi A3 Quattro, 2016 Audi A3 Quattro, 2016 Audi A3, and 2015 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Depending on scan tool and protocol used, the information in diagnostic mode 01 may be referred to by different names such as Test - ID (TID), Hex - ID, Component - ID (CID), or On - Board Diagnostic Monitor Identifier (OBDMID).

Diagnostic Mode 01 makes it possible to access current emissions - related measured values and diagnostic data. The original measured values (no replacement values), input and output data and system status information are displayed using Diagnostic Mode 1.

Test requirement

scientia non olet · About LEMON Manuals