LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2017 >> RS 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (GENERIC SCAN TOOL [CNTA, CNTC, CNSB] (5 Of 5) -- (A3 SEDAN)) >> Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Procedures >> Camshaft Position Sensor - G40-, Checking >> General Description

Camshaft Position Sensor - G40-, Checking: General Description

WARNING: This page is about a different car, the 2018 Audi A3 Quattro, 2017 Audi A3 Quattro, 2016 Audi A3 Quattro, 2016 Audi A3, and 2015 Audi A3 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Using the signal from the Camshaft Position Sensor -G40-, the precise position of the camshaft relative to the crankshaft is determined very quickly when the engine is started. Used in combination with the signal from the Engine Speed Sensor -G28-, the signal from the Camshaft Position Sensor -G40- allows the Engine Control Module -J623- to detect which cylinder is at TDC. The fuel can be injected into the corresponding cylinder and ignited.

scientia non olet · About LEMON Manuals